Differenze tra le versioni di "Millefori: rounded tracks in your PCB"
(Creata pagina con 'The new version of millefori ([http://www.raspibo.org/renzo/millefori04.0.tgz Click HERE to download Millefori]) includes a new feature: rounded tracks. In fact angles in tra...') |
m |
||
(6 versioni intermedie di uno stesso utente non sono mostrate) | |||
Riga 1: | Riga 1: | ||
+ | Millefori was introduced by my posting: [[Millefori: draw, print, mill and drill your experimental PCBs]]. | ||
+ | |||
The new version of millefori ([http://www.raspibo.org/renzo/millefori04.0.tgz Click HERE to download Millefori]) includes a | The new version of millefori ([http://www.raspibo.org/renzo/millefori04.0.tgz Click HERE to download Millefori]) includes a | ||
new feature: rounded tracks. | new feature: rounded tracks. | ||
− | In fact angles in tracks can produce signal | + | In fact angles in tracks can produce signal reflections on high frequencies. |
There are two new command options for the millegcode program: | There are two new command options for the millegcode program: | ||
Riga 8: | Riga 10: | ||
-R | -R | ||
− | Both options generate | + | Both options generate rounded tracks. Lower case r uses segments (gcode g1) to generate the rounded end of a track, while upper case R |
uses gcode arc commands (g2/g3). | uses gcode arc commands (g2/g3). | ||
My 3d-printer uses the Marlin firmware. G2/G3 arcs are roughly approximated, the result is poor. | My 3d-printer uses the Marlin firmware. G2/G3 arcs are roughly approximated, the result is poor. | ||
− | -r seems to work well. The gcode file is quite longer, this is the only minor | + | Instead -r seems to work well. The gcode file is quite longer, this is the only minor drawback. |
Here is an example of a PCB milled using this new feature! | Here is an example of a PCB milled using this new feature! | ||
− | [[File: | + | |
+ | [[File:roundpcb.jpg|400px]] |
Versione attuale delle 08:05, 4 mag 2015
Millefori was introduced by my posting: Millefori: draw, print, mill and drill your experimental PCBs.
The new version of millefori (Click HERE to download Millefori) includes a new feature: rounded tracks.
In fact angles in tracks can produce signal reflections on high frequencies.
There are two new command options for the millegcode program:
-r -R
Both options generate rounded tracks. Lower case r uses segments (gcode g1) to generate the rounded end of a track, while upper case R uses gcode arc commands (g2/g3).
My 3d-printer uses the Marlin firmware. G2/G3 arcs are roughly approximated, the result is poor. Instead -r seems to work well. The gcode file is quite longer, this is the only minor drawback.
Here is an example of a PCB milled using this new feature!